Valence Electron in Electron Configuration

2.7: Applications of Electron Configurations: Valence Electrons and Electron Dot Structures

1. Last updated

2. Save as PDF

Page ID

214189

LEARNING OBJECTIVES

• Determine the number of valence electrons in an atom.
• Draw an electron dot structure for an atom.

Valence Electrons

As was mentioned in a previous section of this chapter, electrons are highly important, because a specific subset of electrons, called valence electrons , are solely-responsible for determining how elements bond with one another.  The number of valence electrons that are present in an atom can be determined from that atom's electron configuration.  Valence electrons are found in the orbitals associated with an atom's highest occupied energy level.  The remaining electrons, which are called inner shell electrons, do not participate in bonding and are, therefore, not important to study.

Consider sulfur's electron configuration, which was determined in the previous section and is replicated below.

1 s ² 2 s ² 2 p ⁶ 3 s ² 3 p ⁴

Recall that the energy levels in an electron configuration are theleading red numbers that denote the start of a new energy level/orbital combination.  Sulfur has electrons in the first, second, and third energy levels, as indicated by the leading red 1, 2's, and 3's, respectively.  Valence electrons are those found in thehighest occupied energy level.  Therefore, in this case, only those electrons associated with anenergy level/orbital combination beginning with a3 need to be considered.  Since two energy level/orbital combinations begin with a3, both orbitals are selected for further consideration:

3 s ² 3 p ⁴

The superscripts associated with these orbitals total to 6.  Therefore, sulfur has 6 valence electrons.

Example \(\PageIndex{1}\)

Determine how many of nitrogen's electrons are classified as valence electrons.  Nitrogen's electron configuration, which was determined in the previous section, is shown below.

1 s ² 2 s ² 2 p ³

Solution

Nitrogen has electrons in the first and secondenergy levels, as indicated by the leading red 1and2's, respectively.  Valence electrons are those found in thehighest occupied energy level.  Therefore, in this case, only those electrons associated with anenergy level/orbital combination beginning with a2 need to be considered.  Since two energy level/orbital combinations begin with a2, both orbitals are selected for further consideration:

2 s ² 2 p ³

The superscripts associated with these orbitals total to 5.  Therefore, nitrogen has 5valence electrons.

Exercise \(\PageIndex{1}\)

Determine how many of the electrons in each of the following elements are classified as valence electrons.  Each element's electron configuration, which was determined in the previous section, is shown below.

1. Neon

1 s ² 2 s ² 2 p ⁶

1. Calcium

1 s ² 2 s ² 2 p ⁶ 3 s ² 3 p ⁶ 4 s ²

Answer a

Neon has electrons in the first and secondenergy levels, as indicated by the leading red 1and2's, respectively.  Valence electrons are those found in thehighest occupied energy level.  Therefore, in this case, only those electrons associated with anenergy level/orbital combination beginning with a2 need to be considered.  Since two energy level/orbital combinations begin with a 2, both orbitals are selected for further consideration:

2 s ² 2 p ⁶

The superscripts associated with these orbitals total to 8.  Therefore, neon has 8valence electrons.

Answer b

Calcium has electrons in the first, second, third, and fourthenergy levels, as indicated by the leading red 1,2's,3's, and4, respectively.  Valence electrons are those found in thehighest occupied energy level.  Therefore, in this case, only those electrons associated with anenergy level/orbital combination beginning with a4 need to be considered.  Since only oneenergy level/orbital combination begins with a 4, only one orbital is selected for further consideration:

4 s ²

The superscriptassociated with thisorbital is a2.  Therefore, calcium has 2valence electrons.

While an electron configuration representsall of the electrons present in an atom of an element, chemists are only truly interested in an atom'svalence electrons, since, as indicated above, those are the electrons that are solely-responsible for determining how elements bond with one another.  Therefore, finding a "shortcut" for determining how many valence electrons are present in an atom would be highly convenient.  Such a "shortcut" does, indeed, exist.  In a previous section of this chapter, three systems for labeling the groups, or columns, on the periodic table were presented.  The second system, which is called the "A/B System," was indicated to provide insight into the electronic character of elements found within that group.

Again, consider sulfur, S, which, based on its electron configuration, has6 valence electrons.

Sulfur is located in the 16^th column of the periodic table.  However, the "A/B System" is used to label the main group elements .  Group 16 is the 6^th column in the main group, or "A-Block," columns of the periodic table and so is labeled as Group 6 A .  Note that sulfur's valence electron count matches its group number in the "A/B System."  This connection applies to nearlyall elements found in themain group columns of the periodic table.  Helium is the only exception to this rule, as it is found in Group 8A, but only contains two total electrons.  This inconsistency invalidates the "A/B shortcut" method, and the electron configuration method must be employed to determine that both of helium's electrons are valence electrons.

Since the "A/B System" group number corresponds to the number of valence electrons that are present in an atom, all elements found within the same column have the same number of valence electrons.  Since an atom's valence electrons are solely-responsible for determining how elements bond with one another, this commonality in electronic character explains why all of the elements within the same group share similar properties.

Example \(\PageIndex{2}\)

Based on its location on the periodic table, determine how many of nitrogen's electrons are classified as valence electrons.

Solution

The "A/B System" group number indicates the number of valence electrons that are present in an atom.  Nitrogen (N) is located in the 15^th column of the periodic table.  However, the "A/B System" is used to label the main group elements .  Group 15 is the 5^th column in the main group, or "A-Block," columns of the periodic table and so is labeled as Group 5A.  Therefore, nitrogen has 5 valence electrons.  (This answer is consistent with the solution to Example \(\PageIndex{1}\).)

Exercise \(\PageIndex{2}\)

Based on the periodic table, determine how many of the electrons in each of the following elements are classified as valence electrons.

1. Neon
2. Calcium

Answer a

The "A/B System" group number indicates the number of valence electrons that are present in an atom.  Neon (Ne) is located in Group 18, which is labeled as Group 8A, using the "A/B System."  Therefore, neon has 8 valence electrons.  (This answer is consistent with the solution to Exercise \(\PageIndex{1}\text{a}\).)

Answer b

Calcium (Ca) is located in Group 2, which is labeled as Group 2A in the "A/B System."  Therefore, calcium has 2 valence electrons.  (Again, this answer is consistent with the solution to Exercise \(\PageIndex{1}\text{b}\).)

Electron Dot Structures

Electron dot structures surround the elemental symbol of an element with one dot for every valence electron that the element contains.  When drawing an electron dot structure, three rules must be followed:

1. The first dot can be placed on any "side" of the elemental symbol (top, bottom, left, or right).
2. The first four dots must each be placed on their own "side" of the elemental symbol.  In other words, if the first dot is placed on the top of the elemental symbol, the second dot can be placed on the bottom, left, or right of the symbol, butcannot be placed at the top, alongside the first dot.
3. The final four dots can again be placed on any "side" of the elemental symbol, but must be arranged such that no more than two dots exist on any "side" of the elemental symbol.

Again, consider sulfur, which has 6 valence electrons.

The elemental symbol for sulfur is S.  Since an electron dot structure surrounds an elemental symbol with one dot for everyvalence electron that the element contains, sulfur's elemental symbol must be surrounded by 6 dots.  Based on the rules given above, the dot representing sulfur's first valence electron can be placed on any "side" of the symbol, as shown below in Figure \(\PageIndex{1}\).

Figure \(\PageIndex{1}\): Possible first-dot placements for sulfur's electron dot structure.

If the first structure in Figure \(\PageIndex{1}\) is chosen as the basis of sulfur's electron dot structure, the dot representing sulfur's second valence electron can be placed on the bottom, left, or right of the elemental symbol, butcannot be placed at the top, alongside the first dot.  Figure \(\PageIndex{2}\) shows three structures with acceptable placements for sulfur's first two valence electrons, as well as a structure with an incorrect electron arrangement.

Figure \(\PageIndex{2}\): Possible second-dot placements for sulfur's electron dot structure.

If the final structure in Figure \(\PageIndex{2}\) is chosen as the basis of sulfur's electron dot structure, the dots representing sulfur's third and fourth valence electrons must be placed on the bottom and to the left of the elemental symbol, butcannot be placed at the top or to the right of the elemental symbol.  Figure \(\PageIndex{3}\) shows the only structure with an acceptable placement for sulfur's first four valence electrons.

Figure \(\PageIndex{3}\): The correct four-dot placement for sulfur's electron dot structure.

The dots representing sulfur's fifth and sixth valence electrons can again be placed on any "side" of the elemental symbol, but cannot both be placed on the same "side," so that no more than two dots exist on any "side" of the elemental symbol.  Figure \(\PageIndex{4}\) shows all of the structures with acceptable placements for sulfur's six valence electrons.  Therefore, any of the structures in Figure \(\PageIndex{4}\) is a valid electron dot structure for sulfur.

Figure \(\PageIndex{4}\): Valid electron dot structures for sulfur.

Example \(\PageIndex{3}\)

Draw a valid electron dot structure for nitrogen.

Solution

The elemental symbol for nitrogen is N.  Based on Example \(\PageIndex{1}\) and Example \(\PageIndex{2}\), nitrogen has 5 valence electrons.  Based on the rules described above, the first four dots must each be placed on their own "side" of the elemental symbol, and the fifth dot can be placed alongside any of the first four.  Therefore, any of the following structures is a valid electron dot structure for nitrogen.

Exercise \(\PageIndex{3}\)

Draw a valid electron dot structure for each of the following elements.

1. Neon
2. Calcium

Answer a

The elemental symbol for neon is Ne.  Based on Example \(\PageIndex{1}\text{a}\) and Example \(\PageIndex{2}\text{a}\), neon has 8 valence electrons.  Based on the rules described above, the first four dots must each be placed on their own "side" of the elemental symbol, and each of the remaining four dots must be placed alongside each of the first four.  Therefore, the following structure is the only valid electron dot structure for neon.

Answer b

The elemental symbol for calcium is Ca.  Based on Example \(\PageIndex{1}\text{b}\) and Example \(\PageIndex{2}\text{b}\), calcium has 2 valence electrons.  Based on the rules described above, each dot must each be placed on its own "side" of the elemental symbol.  Therefore, any of the following structures is a valid electron dot structure for calcium.

Valence Electron in Electron Configuration

Source: https://chem.libretexts.org/Courses/Heartland_Community_College/CHEM_120:_Fundamentals_of_Chemistry/02:_Atoms_and_Elements/2.07:_Applications_of_Electron_Configurations_Valence_Electrons_and_Electron_Dot_Structures

Share this post